Alvin Products Lab-metal 10102 Metal Repair and Patching Compound, 24 oz Can, Paste Form, Gray, 1.73
Item #:
LABMET 10102
Product Info
Alvin Products
Manufacturer Part #: 10102
Alvin Products Lab-metal Metal Repair and Patching Compound, Can Container, 24 oz Container, Composition: 50 to 60% Aluminum Powder, 5 to 10% Methyl Ethyl Ketone, 5 to 10% Toluene, Paste Form, 1 to 2 hr Drying, Gray, Solvent Odor/Scent, 350 to 425 deg F, 1.73 Specific Gravity, 23 to 45 deg F Flash Point, 2.74 lb/gal VOC, 2500 cSt at 40 deg C Viscosity, Applicable Materials: Metal, Wood, Glass, Plaster, Porcelain and Hard Plastic, 650 lb/sq-in Tensile Strength
- Lab-metal fills dents and flaws in metal and nonmetal parts easily and economically
- Apply Lab-metal right from the can with a putty knife or similar tool
- No two-component mixing or measuring is necessary, therefore there is no waste
- Heat, special tools and specialized skill are unnecessary
- Many applications may be made from a single can
- Lab-metal may be thinned to paint consistency with Lab-solvent and brushed or sprayed on practically any surface to provide a rustproof, water resistant, hard metal finish
- Lab-metal adheres to any clean and dry metal, wood, glass, plaster, porcelain and hard plastic surface
- Its strong bond withstands vibration and other difficult conditions
- Lab-metal hardens quickly without heat, providing a durable metal surface
- Once hardened, Lab-metal can be milled, chiseled, drilled, sawed, tapped and machined
- Filing, sanding or grinding Lab-metal to a feather edge provides a smooth metallic repair
- Lab-metal will not shrink, crack or peel
- Not affected by mild acids, gasoline, oil or petroleum solvents
- Lab-metal is aluminum filled, resisting attack of rust, rot and mildew
- Lab-metal withstands temperatures as high as 350 deg F (and as low as -40 deg F) and when hard, can be painted with lacquer or enamel without danger of bubbling, lifting paint, chipping or peeling
- Lab-metal stands up to normal paint baking procedures and may also be powder coated
- Lab-metal's true metal hardness is achieved with greater ease than other materials sold for repair and finishing
- Lab-metal sells for considerably less than epoxy systems
- Its strength, hardness, durability and abrasion resistance surpass basic requirements for fillers set by the nation's largest metalworking plants
Item Specifications
-
Metal, Wood, Glass, Plaster, Porcelain and Hard Plastic
-
Gray
-
50 to 60% Aluminum Powder, 5 to 10% Methyl Ethyl Ketone, 5 to 10% Toluene
-
24 oz
-
Can
-
1 to 2 hr
-
23 to 45 deg F
-
Paste
-
Solvent
-
1.73
-
350 to 425 deg F
-
650 lb/sq-in
-
2500 cSt at 40 deg C
-
2.74 lb/gal